MIDEVIL214
Jr. Member
- Joined
- Feb 7, 2005
- Messages
- 166
I'm adding a new prop valve to my power disk/drum brakes. I had the warning light (74) disconnected for years but decided to hook it up again with the new valve. I spliced the two violet (purple) wires together like Toms and WH suggests. I did a quick test before installing the lines and my warning light stays on when the harness is disconnected from the prop valve switch. It also stays on when connected to the uninstalled prop valve.
Should the light stay on with the harness connector removed from the valve switch? I even removed the switch from the valve and connected the harness. The light stays on...
I'm familiar with the re-centering process once the lines are hooked up. Just worried that its not going to matter because the light seems to stay on no matter what.
http://www.tomsbroncoparts.com/pages/schematics/bronco-schematics/drivetrain/66-77-early-ford-bronco-proportioning-valve-diagram/
Should the light stay on with the harness connector removed from the valve switch? I even removed the switch from the valve and connected the harness. The light stays on...
I'm familiar with the re-centering process once the lines are hooked up. Just worried that its not going to matter because the light seems to stay on no matter what.
http://www.tomsbroncoparts.com/pages/schematics/bronco-schematics/drivetrain/66-77-early-ford-bronco-proportioning-valve-diagram/