brad smith
Jr. Member
Could someone shine some light on how to reassemble the rear license plate bracket. I took it to part and clean not sure how to do it. Any instructions? Thanks in advance.
Community
Message Forum
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Buy / Sell
Bronco Tech
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
License plate holder
- Thread starter brad smith
- Start date
OP
OP
brad smith
Jr. Member
I believe my spring is bent sprung. Are these available?
Appears so:
www.dennis-carpenter.com
Rear License Plate Support Spring - 1966-77 Ford Bronco | Dennis Carpenter Ford Restorations
Rear License Plate Support Spring - Ford Bronco 1966 1967 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 C6TZ17A397A
www.dennis-carpenter.com
OP
OP
brad smith
Jr. Member
I finally got mine put back. I had to bend it just a little. But it went back into place and works like it should.
Similar threads
- Locked
