So the install went as planned on the JB unit purchased from WH. When we tightened the locking nut, we got it tight but was concerned about over-tightening it. Both shifters seemed to move freely without any wobble.
When I'm driving there is no vibration felt. When I come to a stop, I get a vibration in both shifters and a small vibration sound. If I touch the shifters, it stops. When I accelerate, it goes away. So it only happens with the car in gear, and at a full stop. It's not hitting the transmission tunnel.
Thoughts?
When I'm driving there is no vibration felt. When I come to a stop, I get a vibration in both shifters and a small vibration sound. If I touch the shifters, it stops. When I accelerate, it goes away. So it only happens with the car in gear, and at a full stop. It's not hitting the transmission tunnel.
Thoughts?