Brain not working today, please help! Maybe I’m just o er thinking this.
My steps work great, triggered by each door properly as they should…
I wired them and used diodes to isolate each of the door signals which feeds into a single open door feed that runs to let my alarm know the door is open and then also as a dome light trigger.
The problem is that the Amp Control box sends POWER on those door trigger wires, which doesn’t make any sense to me right now. It’s a ground trigger.
If I put in a diode to isolate the power on the trigger wire, the steps do not come down as it doesn’t allow the ground signal to come through either.
Is there something wrong with my step controller or is my brain just not functional this late in the year.
Please help me figure this out.
My steps work great, triggered by each door properly as they should…
I wired them and used diodes to isolate each of the door signals which feeds into a single open door feed that runs to let my alarm know the door is open and then also as a dome light trigger.
The problem is that the Amp Control box sends POWER on those door trigger wires, which doesn’t make any sense to me right now. It’s a ground trigger.
If I put in a diode to isolate the power on the trigger wire, the steps do not come down as it doesn’t allow the ground signal to come through either.
Is there something wrong with my step controller or is my brain just not functional this late in the year.
Please help me figure this out.