Search results

Selling a 1974 Bronco, 302 motor, 3-speed manual transmission, Dana 20 transfercase, Dana 44 front axle, 9" rear axle, power steering. Body is in rough shape and the full-size roof was cut down at some point to create a half-cab. Runs and drives, in fact the engine is very quiet.....no knocks...

Looks like I have some choices to make for my '74 Bronco build-up. Back in the winter I acquired a fuel-injected 302 with the 4-speed auto out of a '89 F-150. Then last week I bought my neighbor's 1980 camperized Econoline van for the 351 and C6. I already know that both engines are tall for...

My buddy has a 5.0L EFI motor with the 4-speed auto tranny out of an '89 F-150. He was going to use it in his Toyota 4runner project rig, but he changes ideas like I change underwear.%) So yesterday he made a deal for a Chevy 305 powertrain and guess what.........yup, he's selling the Ford...

My friend hit a deer yesterday with his low-mileage 455-powered Oldsmobile and it looks like the insurance company will probably write-off the car. Would this engine be a good swap for a '74 Bronco? I know I know......a GM motor in a Ford........but I can get this really cheap and it's in...

A good friend has a fiberglass tub on his CJ-7. This is his daily-driver, but he also offroads it and really flexes the thing out from time to time. He also drives it all winter.....and our temps get as cold as -38 degrees here. He's had it for about three years now with out any issues at...

Pardon my ignorance but in researching EBs this past week I keep reading about guys with 351W & 351C in their rigs. For some reason I know that the W is for Windsor and the C is for Cleveland, simply indicating which plant each motor was manufactured in. But what are the physical differences...

A friend is selling a '74 Bronco he bought a while back for a project, but has changed his mind on. I can get it for $1100 Canadian (approx $900 US). It has a running 302, 3-speed manual, Dana 20 (I think), front Dana 44 w/ drum brakes, and rear 9". Body is uncut but a little rough - need...