Recent content by 73BRO

a have fitech on my fresh rebuilt 351w in my 73 Bronco mine runs great,no problems.just had it out trailriding last weekend. have a sniper my 83 Hurst Olds. a little more of a pain to work with as far as the ignition set up.

They will discolor,goes from shiny to dull a couple of inches from each cylinder

If i remember my ford junkyard days dooe were torino type cars doae were full size cars dote were trucks dozz mustangs first numbers were years,3rd was the model line b`s were the 50`s c`s were the 60`,s d0-70,d1-71,e`s were eighties ford changed them up after the 90`s,now when i see a new ford...

I just sent a couple of pictures to your #

Greenlight makes some nice 1/18 Scale Broncos. Found a couple a a car show vendor this past weekend.

are you still in need of the gears,i am pretty sure I have a set. id have to look at the numbers to be sure

1st start up with fi-tech system.little priming,fired right up. Ran it for a bit, adjusted idle .runs good, Got better the longer it ran. Pouring rain,so no test drive tonight

I'm going with external fitech pump. Made a bracket with a piece of flat steel bolted to frame and pump bolted to that

I tried replacing the steel rear tank on my 1973 with a replacement plastic that was supposed to fit.dont know if it was a bad batch but fitment was terrible. sent it back and got the steel one.fits just like it should. the original one lasted 43 years .showed a little rust under the strap but...

Got a new one of those also. I read something about that. Should i be doing something with that?

It was aftermarket made to replace the steel. Narrower and shorter. Sent it back for steel replacement, fits like it should. Maybe i had a bad one.all is good now

bronco is a 73,purchased plastic replacement for that style tank is narrower and shorter. fitment between rear frame rail braces is bad. thinking of calling about exchange for steel one on Monday. not an off road bronco any more or winter driven anyway

I see a few people are using these. I purchased one and am not happy with the fit at all. anyone else have this issue ? I'm thinking of returning it and getting a steel one

Last time I did it,I put the trans and case in first. Had them attached,with tcase xmember on a transmission jack and lifted onto the xmember frame brackets which I left on the frame.braced things up and then engine. With a friend's help and of course not that easy