- Joined
- Jun 13, 2012
- Messages
- 797
will be replacing the turn signal switch on my 67-manual steering column this weekend. Planning of taping a steel wire to the old wires and pulling it out the column and same for feeding the new wires through. best to remove the column to fish the wires through and work on it properly or can this be done with column in place?
also thinking of wrapping the new wires with electrical tape to prevent any chaffing. will this cause it to not flex/bend to get the wires fished through the column?
JP
also thinking of wrapping the new wires with electrical tape to prevent any chaffing. will this cause it to not flex/bend to get the wires fished through the column?
JP