Engine and trans cross-members are done and I rolled the axles in place. I will try to get some pics of it this weekend once I get the area cleaned up a bit. She is starting to look like a bronco again.
I need to convert the tailshaft and housing on the tcase to a flange style which will give me a little more room to work with a allow and slip joint with enough spline for the suspension travel. I then need a rear driveshaft made and can work on the 4-link.
I want to install twin turbos and right now I don't have enough room upfront for both a radiator and an intercooler so I am debating on whether I mount the radiator in the rear or will use two small intercoolers and find room around the wheel well area to mount those.