5.0 EFI water tube and water sensor alternatives

[hahnn6]

does anybody have an alternative part that will delete this tube setup? I'm looking for something that'll still screw into factory intake water port and also house the water temp sensor but allow me to connect to heater hose in that front portion of the engine rather than running to the backside with the factory hose. I've got 1990 5.0 intake and above on the original 302 long block.

 

[pcf_mark]

I do not have the tubes. I have water to and from heater via hoses that travel across to inner wheel well then back to heater. Easy, clean. I have a thermostat that is drilled and tapped for the temp sensor for the gage and the EFI sense is in the other port on the manifold.