Search results

Hello! My carb is leaking in a spot I'm unfamiliar with. Can't see a visible leak or gasket. I'm pretty familiar with this carb, but this has me stumped. I'd appreciate any feedback! JB

Thanks to everyone who voted for #80! 54 votes. Maybe next year!

Go #80!!! Last in the poll, first in our hearts. I'm biased too lol.

Wow! Very interesting!

Just added some more to my original post. Enjoy!

Love the way these turned out. Putting the hard top on this evening... will have to get some more!

wow, thanks everyone. I will have those tire #s when I get home. I have this tach at home, just haven't installed. It is tough to do? Built my EB from the ground up but I used the original wiring harness (and a lot of solder, haha).

I'm trying to get up to 60mph in my '72 with a 200i6 and 4.56 gear ratio. I feel like I have enough pedal to do it but at 50mph or so it feels like I'm really pushing the vehicle. I don't have a tach installed. Any suggestions? Thanks, JB

Green 72 here!

Quick Update Installed a Bikini top and a hi lift on the roll cage! Here she is at Hidden Falls.

Seldnut, How did you check grounds? Do you mean the connections or the current or both? Thanks.

Thanks SteveL, tried this as well. Dumb question, but how hard should I hit with rubber mallet? I'm assuming just a light tap all over, right? Motor is cold. Eoth, are you talking about laying a screwdriver across the top two terminals on the solenoid?

When turning key, the solenoid lets out a single *click* noise. I have checked all connections and tried two different batteries, both which tested well and started a CJ-5 minutes before. The cable running from the solenoid to the starter looks as if it is sending power to the starter, as it...

Mine is light Jade

Hey There, Had my cluster refurbished and the speedometer is about 10 miles slower than actual speed. Is there a way to tune this? Thanks! JB

The air/fuel ratio screw fixed an issue similar to this one for me. Sounds like you may have a blockage somewhere, but I think tuning the screw first would be an easy way to start the troubleshooting process. Loosen it close to all the way, see what happens, then make it pretty tight and see how...

Thanks Tikiclub!

Got my LED's wired up behind the grille - pretty cool look at them attached.

Does anyone have pics of this cage installed in their EB? http://www.tomsbroncoparts.com/product/interior-roll-bar-cage-family-4-point-66-77-early-ford-bronco-new Looking at putting this in my stock-ish build. Thanks! JB

Hahaha - I was just talking about this last night!