Skiddy
Bronco Guru
- Joined
- Oct 8, 2003
- Messages
- 11,557
When selecting a torque wrench for a job one of the most important part is to have a wrench that is correct size for the job not too large of a range and not too small. You want a wrench that is close to middle of the range as possible (i.e. if you need to torque at 75 ft. lbs you would want to use a 0-150 lb torque wrench) one rule of thumb is ¼ to ¾ of the range, that way you get the most accuracy out of the tool. If you are planning on using your torque wrench quite often you will want a good quality brand. Never use a torque wrench as a ratchet as this will wear it out prematurely also it will strip the gears and slip on you leaving you with bloody knuckles we know no one likes that. Also do not use them to loosen bolts and fasteners. Another key thing is when done using your torque wrench always return the setting back to zero this relieves strain off the springs. As always keep you tools clean and dry as possible. So the next time you go to use it it’s in good working order and should still be accurate.
Note: it is always a good idea to put a little oil/grease on the fastener head to help insure you are getting the correct torque.
If you have anything to add to this FAQ please respond below
Kenny Ramsey (Skiddy)
Note: it is always a good idea to put a little oil/grease on the fastener head to help insure you are getting the correct torque.
If you have anything to add to this FAQ please respond below
Kenny Ramsey (Skiddy)
Last edited: