Hello! Just took my bronco for the first drive after complete rebuild w/2.5" suspension lift. Had some mad vibration under acceleration, because i'm an amateur I thought I could get by without lengthening the driveshaft but after looking more closely, I think its necessary. See picture
Is it as simple as cut it in half, figure out the tube size and thickness, order tube, cut off the ends of the driveshaft, weld in new tube at longer length? (In my case I think I need about 4") then paint and install?
Is it as simple as cut it in half, figure out the tube size and thickness, order tube, cut off the ends of the driveshaft, weld in new tube at longer length? (In my case I think I need about 4") then paint and install?