Search results

Hello, Does anyone know where I would weld the tabs on a roll bar for the 3 pt shoulder harness seat belts? I’m installing the traditional 4-point Interior Bar for 66-77 Classic Ford Bronco. I do not have my seats in the bronco ( doing a full frame off resto). Need to paint my roll bar and...

I bought a full package lift kit and after the install, my bronco now has a very noticeable lean / uneven stance to it. The left side of my bronco is sitting about half inch higher than the right side. Everything on the bronco was straight before the lift kit ( coil springs, Bilstein shocks...

Thank you Paul, always appreciate your timely and detailed responses. 1. Both sides were even before the install. 2. It’s a 2.5 inch lift, everything is new (complete frame off) 3. Body is on, engine, etc... no interior yet or anything. We will see as time goes on if it can true up a bit...

Hello, I put new lift kit and suspension on my 73 bronco. My issue is the left driver side coil springs (from Wildhorse) is sitting up an inch higher than right side. Measuring height from floor up. Tried adjusting the Radius Arm and C-Bushing adjustments (tighten and loosen) and that...

Hello, I am putting my frame back together and curious if anyone has a picture showing the cross member in it? Looking to make sure how the transfer bushings face. If anyone can confirm or has a picture, it would be much appreciated!

Broncobowsher, thank you for that and the fast reply.

Installing rear (Wilwood) disc brakes, large bearing. As of now I can’t get the rear drivers side axel bearing pulled in. The axel splines line up. The right side everything went together fine. However, it just seems the left side will not go all the way in to get started. Anyone have any...

Has anyone ever used Reatomod Air for their AC? If so, how has the install been and did you use any specific kit? I’m going to do custom vents in my dash. I can get a discount though if I order the bundled AC package. Thank you!

Thanks Paul

I’m trying to do a dash similar to the one shown in the photo. Basically adding AC vents directly into the dash. Does anyone have a template or guidance? I’m thinking to delete all the knobs on my dash besides the lights, hazard, wash, but not certain. Thank you in advance.

Great feedback, much appreciated

I am going to run AC and curious if a 1” body lift would help make the AC unit fit under the hood better and possibly keep it running cooler? It’s a 73 bronco with 2.5 body lift and 33’s. Someone told me they recommend doing a 1” body lift if you run AC, but wasn’t really sure the reasoning...

Hello, I’m in the later stages of building my 73 bronco that has grafted fenders in the rear (similar to what is shown in the attached pciture). I’m running a 2.5” lift with no body lift. My question is can I run 15” wheels with 33” tires and have enough clearance, so I don’t have any...

Well done, looks good! Appreciate you keeping us along for the build. Cheers!

Looking forward to it! A lot of newbies seeking out content on what to look for / not when buying a bronco. Would be good to do a podcast to help out the new buyers. Ie: common rust spots, VIN details, etc...

Curious if anyone has used the Wilwood disc brakes setup over the more standard option. Worth the extra cost? Any pros / cons? Any modifications needed for the Wilwood setup? I have a 1973 undergoing frame off... restomod keeping the original 302 in it. Thanks in advance!

Sorry for your loss. Looks like you have some great memories with Harley.

Excited to watch this build. You’re already off to a fast start.