Search results

is there a way to test a turn signal switch?

must be 25 years ago I think I can remember having the same issues and I think it was a new turn sig sw back then that solved the problem. it does seem like its a bad turn sig sw. this new scot drake did fix the hazard light and the stop light problems. just not the turn indicators. is...

it's a scott drake

I have replaced the turn signal switch, this is what happens now. the warning flasher works now like normal. stop lights work like normal. still no turn signals. except when the warning flasher is activated and I turn on a turn signal the turn signal flasher pulses along with the warning...

when I step on the brake only the drivers side lights up. then when I turn on the left turn signal the brake light goes out. with the warning flasher on no lights. step on the brake back left light comes on and so do the front parking lights but, they don't blink. sometimes I can hear the...

I have no turn signals. and I have no emergency flasher.

i'm trying to decide if my flasher is good or bad. should I be getting continuity from tab to tab or not?

why don't my turn signals and my emergency flasher work? everything else works. where are they connected? what should I be looking for? its a 1969 bronco. long time problem. lost. about ready to light a fuse.

thank you. it was driving two of my personalities nuts.

i'm trying to install a new flywheel but, the holes are just slightly off it seems . am I missing something? is there a trick to it?

I have just replaced my clutch and am putting it all back together. I have a bracket that I don't know where it belongs. I know it was attached to the transmission to transfer case extention. and I think it was on the transfer case end. I don't remember what it was for. could someone...

to satisfy some people's curiosity I am asking this. if you ordered say a rebuilt transmission or had one rebuilt and it came to you sealed up ready to be installed. would you open it up anyway costing a gasket, to have a look inside? or trust that everything is ok and just install it.

does the pilot bearing pull straight out? mine seems very stuck.

I have the kind of dipstick where the tube just pushes into the oil pan and it leaks all the time. has anyone found a remedy for that? I have thought about wraping Teflon tape around the tube but, am afraid the tape will end up in the pan eventualy.

I am replacing the flywheel in my bronco. i'm to the part where the clutch release lever and throw out bearing are removed and i'm not certain how its done. does the clutch release lever and throw out bearing come out when the flywheel housing is removed? can they be removed before...

thanks guys. its a rat

my ford 3.03 transmission no longer has a tag determining rat or ran. is there another way to tell rat from ran? I don't see any markings on the case. is one case larger than the other? mine is 9 3/4 long.

I found brass filings in my 3 speed tranny. quite a bit. am I correct that the brass gears are the syncro gears? are those the only thing brass in the tranny? they all ( brass gears ) kind of float freely. is that normal? i'm wondering at what point do I need to rebuild. I don't...

the repair manual talks about a shield covering the transfer case. did broncos come equipped with one? I don't have one. but, i'd like to see one. could someone post a picture of one. please. I could have used one when I hit a rock and cracked my transfer case. today i'm removing...

is the up grade to twin sticks difficult? any special tools needed? who did you order parts from? were instructions included? was it worth it?