Search results

I cant seem to change my avatar, i keep getting the message: Upload of file failed I have resized my pic and made it smaller than the sizes state but i continue to get the same message, i have tried a few different pics and no luck. does anyone have any ideas? Thanks

this top is kinda cool, i think. I really dig the doors though. http://www.rockyroads.com/ go to the sales lot and check out the 1970 drifter.

I have a 76 with the stock power front discs and stock rear drums. For some reason my rears seem to be locking up before the front(i'm not sure the fronts are locking up). What would cause this? I dont see any fluid leaking from anywhere, and both the wheel cylinders and drums are new. This just...

What do i need to do to my engine until i complete it? I have the heads on, valve covers, intake, carb, headers and the oil pan. Should i just put some spaprk plugs in it and call it good? It has been sitting wrapped in plastic for 6-8 months but it may be a few more before pull my current motor...

I'm looking for the pass side vent box and heater ait inlet(i think i tossed mine). Anyone have one laying around they want to part with. Thanks

This is interesting: http://www.rockyroads.com/ check out the sales lot.

http://128.83.80.200/taco/scarysteering.html :o :o :o :o :o :o %) %) %) %) %) %)

I know its a Jeep but;

After changing my steering from the inverted y to the conversion from complete offroad i want to put my steering stabilizer back on but of course now it seems way too long. I measured over from the pitman arm to the bracket on my old setup and put the bracket back in the same place on my new...

For some reason i seem to have changed something somewhere and now i dont get notified by email when someone responds to a thread that i have posted in and i dont get notified if someone PM's me. What can i do to fix this? Thanks, Alex

I'm going to replace the lockout hubs on my '76 D44, and i need to find something inexpensive($100 or less). I've seen some Warns on Ebay(don't recall the model) and i've heard talk of the Milemarkers being good for the $. I will be 90% on road so i dont need some badass willy rock crawling hubs...

I got in today to go for a drive and once again it feels like my right rear drum is sticking. As soon as i touch the brakes the right rear immediately locks up. It does this for the first few times i touch the brakes and then it seems ok, that is until i set the parking brake. I drove around for...

OK so like a dummy while re-installing my steering shaft i knocked the jerry rigged wires from my Duraspark II ignition box off and i dont know which one was attached to which. The PO decided to use the same color wires when he "rewired" this thing so both wires coming out of the box are the...

I just got my ps box back from WTO and i seem to have forgotten which hose comes out of the PS pump and goes into which hole in PS box. I'm using the the stock pump and box. Anyone got a pic or a link to schematic that shows which which hose comes from and goes where. Also i have a 76 and i want...

OK, I need to know exactly what year and model harmonic balancer i need so i can tell the MORONS at Vatozone to order me. They dont have one for a Bronco and cant seem to locate one for a 3 bolt pattern. I have searched here and i understand that i need one for a pre-'81 vehicle but they must...

I have my choice of 2 used carbs to use. One is a holley 600cfm w/vacuum secondaries which is in use now and has the kickdown that i need and the other is an edelbrock 1405/1465(off road needles and seats)which needs to be rebuilt and has no kickdown for my c-4. I will be 75% street and 25%...

This is the piece inside an auto column that the shift handle grabs to change the gears. What is it called and where can i get one? I want to replace it while my column is being rebuilt. Also does anyone have a good chrome aotu shift lever or know what year/model i can replace mine with. Thanks...

Looking for a gear indicator cover for my 76 auto column. Thanks

Would it hurt anything if i were to have my edelbrock intake powder coated chrome. Would it trap heat(or does it even matter)or could it discolor the finish.

Is a trak loc like a soft locker or what? I'm confused about what it is and what are they worth?