• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Search results

  1. Cohammer

    Parked on hill , wonÂ’t start

    Well cleaning garage and left my bronco parked in my yard on very steep hill for 3 days . Normally could reach in and just turn key and start but ran battery down trying and noticed fuel tank had emptied. Pulled back up into garage with winch and drained oil and left empty for 7 days ,put oil...
  2. Cohammer

    Emergency brake cables

    Can someone tell me where they bought a complete emergency brake cable system. Two rear cables and front cable to petal , Thanks for any help .
  3. Cohammer

    Fumes

    Any other suggestions on in cab fumes ? While sitting letting it run no fumes seem to get in cab . After driving for a few minutes they get stronger. Have a new exhaust that goes out sides where design, should I take pipes down and weld all clamped joints because they may be expanding? Was a...
  4. Cohammer

    Headlights

    Before I changed my headlights to toms H4 with new wiring pig tail harness and relays I had the same problem. I have read every old post still stumped . When I stomp dimmer switch headlights go out . Changed switch and still same problem. I can take jumper wire and one side of pigtail at dimmer...
  5. Cohammer

    fuse block

    Heading to a pull a part this afternoon to look around . Have any of you got a fuse block out of a certain model vehicle that may work well ?
  6. Cohammer

    Engine heat

    I have put vintage air in my 74 but after driving about 50 miles in 95 degree heat my front floor board , dash and even the key was hot from engine bay . What is the best way to eliminate the heat transfer from engine bay and up thru floor board . I se many products but what has been used that...
  7. Cohammer

    GA Elgin national coffee mill

    Elgin national mill with stand , 6 feet tall 30 inches wide , not any complete ones out there at this price .
  8. Cohammer

    Regulator

    Noticed some rotten wires around my voltage regulator . Got a new one and changed plug , new one got hot . Took it back off and made sure of ground then put old one back on . Motor runs great until I plug in the voltage regulator and at idle motor bogs down when I plug in regulator . Unplugged...
  9. Cohammer

    Voltage regulator

    Went to get a new voltage regulator for my 74 and when installed it drove 3 miles to the store and wires were smoking . Unplugged it and headed back home . The regulator got real hot not sure why looked like it was wired right even used new plug . Is there something different about this small...
  10. Cohammer

    Rear drums

    The Dailey problems just keep coming . Was proud to redo my whole exhaust system and go for a spin , got back thought pipes were just burning off but right rear drum burning and smoking . I put front disk on it and they will stand you on your head so I just left valve off going to back brakes...
  11. Cohammer

    Left tire bounce

    I noticed the other day when I went for a drive at any speed if I hit a bump my left tire started to extremely bounce . I could slow down and it would smooth out until I hit another bump . Got under it when I got home and the only obvious I could see looking at each front tire and bushings and...
  12. Cohammer

    GA 1989 crown Vic with 5.0

    Looked at this car today , runs good has 74000 original miles showed me paper work with $536 work done on it plus . My 302 is still running Good right now so I passed . Give this guy a call if you need a 5.0 motor , transmission and complete car for $700 don't think you can go wrong I just don't...
  13. Cohammer

    1989 crown Vick motor

    Dumb question but I have access to a 1989 crown Vick with a 5.0 rebuilt runs great . Wouldn't this be a good swap with my 302 in my 74 .
  14. Cohammer

    Exhaust help

    My 302 on my 74 has dual exhaust and both muffler have holes and need replacing . I searched the old post but I can't find the exact answer I need . I guess I should replace pipes along with muffler . I do see some new products that are 2 into one and see where some say no kit fit exactly ...
  15. Cohammer

    Under dash AC

    I was so proud of my under dash AC I installed but the hissing noise after I closed the hood today was bad . I had been running it about a month but did not realize the hood latch was just rubbing condensor coil . Just a heads up when installing a coil be sure it does not pop back when closed...
  16. Cohammer

    Alternator

    Ok read old post on alternator but one quick question . I checked battery with motor off 12.5 volts I checked with motor running 12.4 volts Took battery cable off motor running it stayed running and checked volts coming back from regulator with battery cable lose 9.0 volts . Good or bad
  17. Cohammer

    Under dash unit

    Anyone used under dash unit with heat and air ? I have compressor installed , condenser and trying to decide if I want unit with heat and air . The only thing I guess I would not have defrost if I take out stock heat . Not sure any thoughts on this ?
  18. Cohammer

    AC bracket

    I am adding AC under dash and I have everything but the bracket that holds compressor to engine . I have looked at many photo but still not sure what I need . Can some one please post a style bracket that mounts to 302 for AC . The compressor I have should lay on its side but I have seen photo...
  19. Cohammer

    Summit all ford event

    Any one ever been to the summit racing ford owners association all ford show . It's the 8 th annual and is July 18 in McDonough Ga Wondered if it's worth the drive .
  20. Cohammer

    Cranking after driving

    302 with a 2100 carb that has electric choke . After going for any short ride when I turn off engine and go back to crank it after about 10 minuates it acts like all the gas has leaked down and is hard to start . I have had 3 different carbs on it and it does it with every one . It seems to...
Top