Recent content by u10072

Haven’t seen my old girl in awhile so I’ll look at her online and try to remember what I’ve forgotten! Going to look at some property in the morning to help get the broncos and VIF back up and rolling again!!

Yea it’s ridiculous

Wait til year 3 and ford will fix plenty of the stuff they’ve already screwed up- hopefully the drivetrain and wheel arches for starters - gawd this thing sucks!

I cant imagine why you would use this short of being a high school kid.

Hello, Not EB sorry but I’m needing a 80-82 Dana 44 Third member if anyone has one to sell. Just text me direct 602.502.8945 Thx- Matt

It’s $1500 to get a good 200 amp Hobart machine, a big tank and all the wiring to run it. Buy better and cry once - buy cheap and buy twice!

Do whatever the engine builder/header builder says. I’ll just say this- nice headers start being built at about $2000 and with that said I would have everything bolted down tight and ready minus the exhaust.

Hold it someone wanted a Gateway vs an Icon? The Gateway is 3 car garage quality but not a very well set up one at that!

You live in CA so shipping is cheap or drive down to Deaver or WH.

I don’t care if you only drive your Grandma to church in the bronco get the 10 leaf!! The old 5 leaf are garbage! You get what you pay for!

Hello all, I’m asking can a coyote alternator that sits low on the drivers side be reclocked like the old 3G units could? I’m asking for a guy with a 66 mustang having chassis interference issues. Just hoping the guys doing the coyote swaps have some good info. Thx, Matt

Sold.....

Hello All, F/S Edelbrock Performer RPM Airgap 7581 intake manifold. I had this thing on for a couple months and have some dyno time and maybe 20 miles as well. There’s literally no clean up time on this due time just not needing it. I don’t have the box but I bought it from sUmmit a year ago and...

Sold......

Spectre 9849 Ram Air Intake Plenum Single 3.5" Tall 4" Inlet Aluminum This item has been installed for some dyno time and a couple short drives. There’s probably a few handling issues with the finish but nothing that’s a detraction. I’m including a urethane coupler that necks down to 3”. I...