Recent content by redtail

You might see if they can get oversized valves installed and save the cost of new seats in the heads.

check for intake to head leaks. Also check your timing. Also, check your ignition system, I have had issues like this with weak spark.

wiggle the turn signal switch in the column and see if the light starts working.

Try and run the two little screws on the side of the carb out 1/4 to a 1/2 turn while the engine is doing the surging and see if that helps. The longers cranking sounds like float level or you are boiling gas in the carb

I have a set of 1966 style lock out hubs. I got them off of a 1966 f100 $80 shipped to your door in the lower 48

Yeah, sorry about that, I got a flood of interest about the box. No worries on the payment. as far as mods, I think it is a bolt in, you would have to find a set of duel groove pullies of course.

I can cut shipping costs a lot if you buy the pump locally. I like to use flat rate boxes and two should fit it all (the pump may not fit is why I ask) so about 35 bucks

Will post tomorrow. box is a 6 turn unit

Stock power steering box/lines/pump/brackets out of a 75 bronco. Stock steering shaft (from firewall to box) comes with as well. Box seems pretty tight, no leaks. $300 plus the ride. Can text or email pics

Yeah, I suppose. I suspect that was the issue as it was one of the only changes you said you made recently. But you never know, could have been it's time

My guess is the pro leaned it out too much, advanced the timing a touch too much... and with a little pinging you now have bad rings... it would take about a week to do the damage :-[

Check your timing, make sure you are at least 8 degrees before top dead center. Also make sure that you are not idled up too high, that can cause a bog with a holly I have found. If you are idled above the transition slots in your holly, it can cause a lean condition right off 'idle' If your...

Make SURE you kept the grounding strap from the breaker plate to the lower, non moving plate. If you don't have this, the points or in your case the unit you are using will not work.

I would make sure your fuel tanks are venting correctly