Recent content by Pokey71

Bump

For Sale Pre runner bumper with winch mount and fairlead mount. Has two 5/8 shackles (6000lbs) my Bronco has a 2" body lift. this can be used without a BL or with a 1,2 or 3 https://www.facebook.com/marketplace/item/1834926816959249/ Located in Folsom,CA $500

I will take one

A. Sway bar mount. Leave it or cut it off B. lowwer ball joints with greese coming out. Dont over grease or wipe them off. If they are the original, time to replace C. No.

Youre going to have to drill the perches out. Nothing wrong with that

you 100 % can. Just make sure you tap it with a plumbing tap : NPT. (national pipe thread)

Take it off, paint it and put it back on. I dont see a huge gain of anything switching a 2 barrel intake to an aftermarket intake.

are you going with the two or four barrel sniper? if its the 2, stay. if its the 4 i would go to a different intake. Why buy an adapter, just buy the right part the first time. Im slowly realizing this

I ran it for 3 years before is snapped and left me on the side of the freeway. I had it plumbed square to the peddle and the carb. It slowly wore and frayed the cable. It was a Lokar cable and they did warranty it. I gave it away and made my own linkage. A mechanical linkage will never brake...

Dont waste your money on a cable. I never liked mine and went back to linkage. I used stainless all thread and linkage ends. I bought the ends from a local napa store...

I still need to correctly wire the voltmeter and replace the voltage reg on the cluster. Looking at bronkenn wiring, looks like i need to thread the pink wire into my bundle and use that for 12v power

Thanks! where did you get power and ground for the new voltmeter?

Like the other two said. Get a 7/8" drillbit and buys these. Will take care of the over reaming problem https://www.ruffstuffspecialties.com/catalog/INSSTEER-2PK.html

do you have any pics of the gauge cluster wired up?