Recent content by hodge's 69

hah Sorry I forgot I dropped it to 9000.

I have a 1969 Bronco up for sale. New Corbeau seats front and back, New seat bealts, New rear driveline, New Tires 33/12.5/15, New eldelbrock carburator 600cfm, New tuffy center console w/covered stereo compartment, New soft top, New exhaust manifold, New headers, New exhaust flowmaster 40...

The bottle actually has the hose from the radiator going to the bottom of overflow bottle and a hose out the top for drainage out.

I recently insatlled an overflow container for my radiator. My question is this, if the stock radiater cap is 13lbs once the pressure is built up pushing the fluid out into the container once the engine cools off how does it suck the fluid back in? I am asking because my container will fill up...

I just put on a 4 barrel carb w/intake that I know is out of adjustment(will be adjusted on friday) and my bronco was over heating with a thermostat, I removed the thermostat and my bronco still runs at around 190f. To me 190w/o a thermostat is funning hot. Is it possible the the carb being out...

I will buy right now email me at hodge7647@yahoo.com

Do oyu still have it? email me at hodge7467@yahoo.com

I run a road demon 625 on my 302 good carb for either the 302 or 351.

floor shifter Thanks a bunch I'll probaly tear into it again when I get done with work. What a pain in the A$$. I think one of my linkage is different. Is that possible?

So I tried and tried but all I can think is the I don't have the right linkage for the bronco(its a used shifter) all the pictures of the kit new are showing 2 different sets of linkage. So I hooked back up the three on the tree and will order a new kit and try again. thanks for the help. -Ty

does anyone have any pictures of the finished product from the uner side?

Ok so I tried the diagram but every time I hook up the shifter and try to shift it binds and will not shift. Any ideas? the brackets in the diagram that hook to the tranny are pointed down but I cannot get the ones on my bronco to point down. The rear bracket points up and the front bracket...

You guys are awesome. I can't wait to get started I'll let you know how it goes. Ty

Hello all I have a silly question. I am new to the bronco world, but I have a 69bronco with 3 on the tree and would like to convert it to a floor shifter. I have a hurst 3 sp floor shifter but have no directions just wondering if anyone can help a brother out. Thank you, Ty