Recent content by hmh800

Yes 68 did have the reflectors. I have a new set of the DC ones that I didn't use in my build. If you're interested in them PM me. I could measure my mounting location if you'd like. Pretty sure they're in the original spots.

I spent less than $300 in tools to set up my R&P. I say do it yourself! It's not that hard, just have to be patient, and be willing to take it back apart for the 8th time if that's what it takes. It's not rocket science.

Yup Nick's right.

I'm looking for a solid, stock tank. Not show quality. I have my efi pump mounted inside my current stock tank, but it's seeping around the seams. Not really interested in an aftermarket style efi tank. My setup works fine. I just don't want a junk, beer-can gauge tank. I get the impression...

Any opinions on who sells the best repop rear gas tank? Thanks

Well they're in. I took off a little of the casting flash on the outsides of the yokes, and they fit through the knuckle. Didn't take much. The inner driver's side shaft was a different story. When i first installed it, it would bottom on something in the differential (yes a limited slip...

OK, so I ground a little bit of material off the outsides of the yokes, and I'm in! Now it seems the inner shaft is too long. It's bottoming in the differential and the slinger is interfering with the spindle. Side by side the inner shaft is about 1/4" longer than the stock one. Anyone else...

yeah I hate to grind on my brand new shafts, but it looks like it's that or the knuckle! Thanks!

Hey guys I recently bought some Chrome Moly axles for the 44 in the front of my 68. Was swapped in before I bought it, not sure of year. I can't get the u joint and yoke through the hole in the knuckle! Should it go, or do I need to take off the knuckle and slide in the shaft? Seems close...

I have a Bestop Bikini new in the box. Came with my bronco when I bought it. I have a full cage so I can't use it. I have the windshield channel, the hardware, instructions, everything. Buyer pays shipping.

I have a full cage from Xtreme Fabrication (I think thats it). I have a rampage soft top as well. I cannot put the top down over the rear hoop. I just barely hits. If I had made the hoop 3/4" lower than the middle hoop it would have cleared. I ran the top of my cage level with the top of...

All valid points, but I can't understand (or accept) that a high dollar radiatior would rot out within 3 years with green coolant and distilled water.

Thanks guys- You have reminded me with the grounding suggestions of stuff I read back when I was putting this thing together. So should the radiator be grounded with a strap or not? I have the motor grounded to frame, body to frame, need to check alternator. Sure seems like this thing rotted...

Hey guys- I bought an aluminum radiator for my project back in 2011. Since then I've put about 2800 miles on it, and it sits all winter in garage. Motor is 351 efi, so it's got the reversed inlet/outlet. This spring I started having a leak in the middle of the core. Can't see it directly, but...

And Rocker, what did you find when you got your Quarterhorse as it related to the hanging idle issue? Was the TPS bad, or out of range? This issue is driving me freakin crazy. Other than this my 351 with Mustang efi runs awesome. Thanks