Recent content by funnycar

The vin is on the inside of the glove box door. The other is on the frame on the passenger side, look straight down the firewall to the frame and thats were its located.

I made a mistake , I have a ford racing reverse water pump

I have a 180 deg.high flow therm. I run a 50/50 mix water and ant. along with a product like water wetter.

I took the heater core out along with the heater. my serpentine belt group is from March and a ford racing rad.

I have a 16" electric pulling fan. Alum. 2 core rad., it has a reverse rotation water pump. I have blocked off openings so that all the air goes thru the rad.. It wont recover after it reaches 200 and keeps climbing up to 250. It doesnt cool down going down the highway or in trafic.

I have a 1975 Bronco with a 392-450 hp. motor. It has a two core ( 1" wide) alumn. rad. This runs around 230 deg. going down the road and will not recover. Cant drive it in the weather here in Texas durning the summer. Thanks Funnycar:

Parking brake pedal over You can unbolt the bracked from the dash and redrill the bracket hole inward towards the steering wheel about a 1 inch. I did this on my '75 to install kickplate speakers without cutting in holes in the plate. I have a 6 point roll cage. Good luck

I have a 75 with a 351/392 and need long tube headers with bigger tubes than 1 1/2. Any suggestions.