Recent content by Blitz51

Bought my 1974 in 2012 from a CB member. Drove it a bit. Moved. Stored Bronco. Moved again. Stored Bronco. Drove Bronco for a summer. Moved again. Stored Bronco. Ordered a 2021. Delayed, became a 2022. Nearly sold 1974. Drove 2022 for two years. Traded 2022 for a new vehicle for wife...

A dance is exactly what I feel like I am doing. Move this, adjust that, tweak that and next thing you know I'm back to square one. I guess if I actually knew what I was doing that would help. I should probably get a timing light and figure out what the timing actually is then proceed. Just went...

That is exactly what it did when I tried to retard it. I did not adjust the screw though. Any idea how much to retard it, or is it trial and error? Thanks for the info.

I have searched the threads and interweb for answers but figured I would pose the question. I have a 351w, holley 1850 carb, edelbrock performer intake, Jacobs pro street ignition, and msd distributor (I think). I recently rebuilt the carb and replaced the starter with a new mini starter. When I...

Hood ? Will you be able to run a stock hood with your setup? What size is your air filter? I have a pretty basic 351w with no body lift and am wondering if going 1" will allow me to run a stock hood. Looks great. Clean and simple.

This is the one I ordered and got from autoZone. It is for an inline 6 they give you the choice between the one for vacuum wipers or not in 1969 and even in the pics they look different. Bizarro world...

That was the source of my confusion. I ordered one for a 69 and it would not fit. The pump arm was longer and at a different angle.

Thanks. If I don't want to run the vacuum wipers do I just can those vacuum ports on the top of that fuel pump?

I need to replace my old vacuum fuel pump on my 66 inline 6 cyl. I am planning to run electric wipers down the road. I ordered one from autozone but the pump arm is different and it doesn't fit. I assume I got the wrong pump. Do I just get get the one for an inline 6 from JBG that says "for...

I pulled the trigger on these yesterday. Couldn't beat it for $40 to my door. They are already being shipped. Any pics of the install of these or an issues would be great. Thanks for the tip!

I know someone posted about an article in USA Today a while back, but now CNNMoney is talking Broncos (on page 3) and old SUV's becoming collectibles. http://money.cnn.com/gallery/autos/2013/04/25/collectible-suvs/index.html

Anyone have experience with these? I think I have isolated my battery drain issues to the ignition module. When I connect the battery cable, there is small spark, the LED input light on the module comes on for a few seconds, then turns off. If I disconnect the module, no spark, no drain. I...

? for DirtDonk again After taking your advice about the drain and fuel gauge I found a couple things. First, the fuel gauge is not even hooked up to the sending unit, so I would assume the gauge has power causing it to show F after turning the key and needs to be actually hooked up to work...I...

Thanks1 Paul, Extremely helpful...thanks for the information. I will check those things out this weekend. However, if it doesn't stop raining in Michigan, I may be turning my bronco into a boat.

DirtDonk I have had the truck for about year, and have been picking away at it to get it on the road since then. A new centech harness was partially installed when I purchased it. The guages were all hooked up, I just had to finish the wiring for the lights and brakes. The fuel gauge has done...